Qos overview, Introduction to qos, Qos service models – H3C Technologies H3C S12500 Series Switches User Manual

Page 30: Best-effort service model, Intserv model, Diffserv model

Advertising
background image

21

QoS overview

Introduction to QoS

In data communications, Quality of Service (QoS) is the ability of a network to provide differentiated

service guarantees for diversified traffic in terms of bandwidth, delay, jitter, and drop rate.
Network resources are scarce. The contention for resources requires that QoS prioritize important traffic

flows over trivial ones. For example, when bandwidth is fixed, more bandwidth for one traffic flow means

less bandwidth for the other traffic flows. When making a QoS scheme, you must consider the

characteristics of various applications to balance the interests of diversified users and to utilize network
resources.
The following section describes some typical QoS service models and widely used, mature QoS

techniques.

QoS service models

Best-effort service model

Best effort is a single-service model and also the simplest service model. In the best-effort service model,

the network does its best to deliver packets, but does not guarantee delay or reliability.
The best-effort service model is the default model in the Internet and applies to most network applications.

It uses the first in first out (FIFO) queuing mechanism.

IntServ model

The integrated service (IntServ) model is a multiple-service model that can accommodate diverse QoS

requirements. It provides the most granularly differentiated QoS by identifying and guaranteeing definite

QoS for each data flow.
In the IntServ model, an application must request service from the network before it sends data. IntServ

signals the service request with the Resource Reservation Protocol (RSVP). All nodes receiving the request

reserve resources as requested and maintain state information for the application flow.
The IntServ model demands high storage and processing capabilities because it requires all nodes along

the transmission path to maintain resource state information for each flow. The model is suitable for
small-sized or edge networks, but not large-sized networks, for example, the core layer of the Internet,

where billions of flows are present. For more information about RSVP, see MPLS Configuration Guide.

DiffServ model

The differentiated service (DiffServ) model is a multiple-service model that can meet diverse QoS

requirements. It is easy to implement and extend. DiffServ does not signal the network to reserve

resources before sending data, as IntServ does.

Advertising