H3C Technologies H3C S12500 Series Switches - Manual (Page 81)

72
Class-based accounting configuration example
IMPORTANT:
By default, Ethernet, VLAN, and aggregate interfaces are down. To configure traffic redirecting for any of
them, use the undo shutdown command on the interface to bring it up first.
Network requirements
As shown in Figure 19 , Host is connected to GigabitEthernet 3/0/1 of Device.
Configure class-based accounting to collect statistics for traffic sourced from 1.1.1.1/24 and received on
GigabitEthernet 3/0/1.
Figure 19 Network diagram
Configuration procedure
# Create basic ACL 2000, and configure a rule to match packets with source IP address 1.1.1.1.
<DeviceA> system-view
[DeviceA] acl number 2000
[DeviceA-acl-basic-2000] rule permit source 1.1.1.1 0
[DeviceA-acl-basic-2000] quit
# Create a class named classifier_1, and use ACL 2000 as the match criterion in the class.
[DeviceA] traffic classifier classifier_1
[DeviceA-classifier-classifier_1] if-match acl 2000
[DeviceA-classifier-classifier_1] quit
# Create a behavior named behavior_1, and configure the traffic accounting action.
[DeviceA] traffic behavior behavior_1
[DeviceA-behavior-behavior_1] accounting
[DeviceA-behavior-behavior_1] quit
# Create a policy named policy, and associate class classifier_1 with behavior behavior_1 in the policy.
[DeviceA] qos policy policy
[DeviceA-qospolicy-policy] classifier classifier_1 behavior behavior_1
[DeviceA-qospolicy-policy] quit
# Apply the policy named policy to the incoming traffic of GigabitEthernet 3/0/1.
[DeviceA] interface GigabitEthernet 3/0/1
[DeviceA-GigabitEthernet3/0/1] qos apply policy policy inbound
[DeviceA-GigabitEthernet3/0/1] quit
# Display traffic statistics to verify the configuration.
[DeviceA] display qos policy interface GigabitEthernet 3/0/1