Configuring a ce1 interface (in ce1 mode), Configuring other ce1 interface parameters, Configuring other ce1 – H3C Technologies H3C SR8800 User Manual
Page 24: Interface parameters
17
After you set the CE1 interface to operate in E1 mode, the system automatically creates a serial interface
numbered serial interface-number:0. This interface is logically equivalent to a synchronous serial
interface where you can configure other settings such as:
•
Parameters of data link protocols such as PPP and HDLC
•
IP address
Configuring a CE1 interface (in CE1 mode)
To configure a CE1 interface in CE1 mode:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter CE1 interface view.
controller e1 number
N/A
3.
Set the interface to operate in
CE1 mode.
using ce1
Optional.
The default operating mode is CE1
mode.
4.
Bundle timeslots on the
interface into a channel set.
channel-set set-number timeslot-list
list
N/A
5.
Set other interface
parameters.
See “
.”
Optional.
A CE1 interface in CE1 mode can be used as a CE1 interface where a serial interface is created upon
creation of a channel set. You may bundle the timeslots on a CE1 interface into up to 31 channel sets.
For each channel set, the system automatically creates a serial interface numbered serial
interface-number:set-number. This interface is logically equivalent to a synchronous serial interface
where you can configure other settings such as:
•
Parameters of data link protocol such as PPP and HDLC
•
IP addressing
Configuring other CE1 interface parameters
To configure other CE1 interface parameters:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter CE1 interface view.
controller e1 number
N/A
3.
Configure the interface
description.
description text
Optional.
The default description is Interface
name Interface.
4.
Set the line code format.
code { ami | hdb3 }
Optional.
The default is high density bipolar
3 (HDB3).
5.
Set the cable type.
cable { long | short }
Optional.
The default cable type is long.