H3C Technologies H3C SR8800 User Manual
Page 58
51
3.
Create an E3/T3 channel and configure its operating mode
To create an E3/T3 channel and configure its operating mode on a 622 Mbps E-CPOS interface:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter 622 Mbps E-CPOS interface
view.
controller e-cpos
interface-number
N/A
3.
Enter OC-3 view (the view of a 155
Mbps channel).
oc-3 oc-3-number
N/A
4.
Configure the operating mode of the
E3/T3 channel.
•
Configure the E3 channel to
operate in unframed mode:
e3 number unframed
•
Configure the T3 channel to
operate in unframed mode:
t3 number unframed
Use either approach.
By default, no E3/T3 channel
is created.
Configuring the operating mode for a 155 Mbps E-CPOS interface
You can use the using command to configure a 155 Mbps E-CPOS interface to operate in channelized
mode or concatenated mode.
•
To create POS channels, configure the concatenated mode. On a 155 Mbps E-CPOS interface in
concatenated mode, you can create one 155 Mbps POS interface.
•
To create E3 or T3 channels, configure the channelized mode.
1.
Configure the operating mode of a 155 Mbps E-CPOS interface
To configure the operating mode of a 155 Mbps E-CPOS interface:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter E-CPOS interface view.
controller e-cpos interface-number N/A
3.
Configure the 155 Mbps
E-CPOS interface to operate
in concatenated mode.
using { oc-3 | oc-3c }
The default is the channelized
mode.
2.
Create an E3/T3 channel and configure its operating mode
To configure the operating mode of an E3/T3 channel on a 155 Mbps E-CPOS interface:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter 155 Mbps E-CPOS interface
view.
controller e-cpos interface-number
N/A
3.
Configure the 155 Mbps E-CPOS
interface to operate in channelized
mode.
using { oc-3 | oc-3c }
The default is the channelized
mode.