H3C Technologies H3C MSR 50 - Manual (Page 38)

30
Figure 24 AUX cable
Connecting the AUX cable
Follow these steps to connect the AUX cable.
Step1 Plug the RJ-45 connector of the cable into the AUX port on the main control board.
Step2 Plug the DB-25 or DB-9 connector into the serial port on the analog modem.
When using the AUX interface for remote configuration or dial backup, you need to connect the local
modem to the remote modem through PSTN and then to the remote device. For the configuration
procedures, refer to MSR Series Routers Configuration Guide.
Interface Card Module
The MSR 50 Routers are available with various types of interface card modules. For detailed information,
refer to MSR Series Routers Interface Module Manual.
Installing/Removing Slide Rail
MSR 50 Slide Rail
SIC slide rail
Figure 25 SIC slide rail