Replacing vpm, Vpm structure – H3C Technologies H3C MSR 50 User Manual
Page 83
Advertising
75
Figure 60 Install memory bar into the slot
Follow the steps below to remove the memory bar:
Step1
Make sure all power interfaces are shut down, and then proceed.
Step2
Press the spring clips on the two sides of the memory bar, and pull outwards levelly until the memory bar
separates with the spring clips and forms an angle of 45 degrees with the main board.
Step3
Remove the memory bar.
Figure 61 Remove memory bar from the slot
Replacing VPM
VPM Structure
Figure 62 VPM structure
Advertising