H3C Technologies H3C MSR 50 - Manual (Page 43)

35
Figure 32 Local configuration connection interface
Step2 Set serial interface parameters. As shown in Figure 33 , in the properties dialog box of the serial interface,
set the baud rate to 9600, data bit to 8, no parity check, stop bit to 1, and flow control to none. Then,
click OK to return to the HyperTerminal window.
Figure 33 Set serial interface parameters
Step3 Set HyperTerminal properties. Select File > Properties > Settings to enter the aaa Properties window as
shown in the following figure. Select the terminal emulation type to be VT100 or Auto detect, and click
OK to return to the HyperTerminal window.