Grass Valley 3430AP CopperHead - Manual (Page 3)

iii
CopperHead 3430AP
User Manual
Safety Compliance
Electromagnetic Compatibility
This equipment complies with:
• CSA/UL/IEC/EN 60950-1, 2nd Ed., for Information Technology Equipment -
Safety requirements
The power cord supplied with this equipment meets the appropriate national
standards for the country of destination.
WARNING: An appropriately listed/certified mains power supply cord must be used
for the connection of the equipment to the mains voltage at either 120V~
or 240V~.
CAUTION: These servicing instructions are for use by qualified personnel only.
To reduce the risk of electric shock, do not perform any servicing other than that
contained in the operating instructions unless you are qualified to do so. Refer all
servicing to qualified service personnel.
Disconnect all power supplies before servicing.
This equipment has been tested for verification of compliance with FCC Part 15,
Subpart B requirements for Class A digital devices.
NOTE: This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the user will be required to correct
the interference at his own expense.