Grass Valley 3430AP CopperHead - Manual (Page 46)

34
Installation and Connection
Connectors into and out of the CopperHead 3430AP Camera Unit Back Side
1 3G/HD/SD Dual Link Inputs
BNC Connectors – Carries 3D/Dual Link camera video from the Camera(s) to the Camera
Unit. This requires BNC jumper cables between the Camera Unit and the Camera (s).
2 HD/SD - SDI Output
BNC Connector – Carries return video from the Base Station to the Camera Unit. Typically
this will feed a camera viewfinder or an HD viewing monitor at the camera location.
3 VBS In
BNC Connector – Carries SD Analog video from the Camera to the Camera Unit. This requires
a short BNC jumper cable between the Camera Unit and the Camera. Can be used to pro-
vide technical monitoring from camera as with superimposed camera menus and other
information.
4 VBS Out
BNC Connector – Carries SD Analog video from the Base Station the Camera Unit. Typically
this will feed an analog viewing monitor or prompter at the camera location.
5 Ethernet Out
RJ45 Connector – Carries IP Data. Typically connects to a Laptop computer or perhaps a
wireless access point at the camera location. Any IP traffic controlled equipment can be han-
dled through this signal path.
6 Fiber Connector
Swivel Mounted SMPTE 304M Fiber Optic Cable receptacle.
7 Time Code Out
BNC Connector – Carries Time Code signal from the Camera Unit to the Camera. This is mas-
ter time code from the Base Station. This requires a short BNC jumper cable between the
Camera Unit and the Camera.
8 Aux Power Output
XLR 4 Pin Female Connector – Provides 17 VDC power to accessories on or near the camera.
Insure that the total power consumption of 30 watts is not exceeded.
9 Audio 1 & 2 Out
XLR 5 Pin Male Connector – Provides Return Audio Out from camera for Channels 1 & 2. Typ-
ically connected to a local monitor at the camera position.
10 Intercom Headset Out
XLR 5 Pin Female Connector – Provides two channels of two-way intercom and the Intercom
Program audio feed
11 Data Connector
Multi-Pin Connector B – DB15 15 Pin Serial Connector. This carries serial control signals for
lens and remote pan & tilt units as well as GPI, Intercom Trigger (GPI) and Tally signals.
Miranda Technologies Inc. supplies a number of pre-configured breakout cables for use