Connections to the copperhead 3400 base station – Grass Valley 3430AP CopperHead User Manual
Page 42
30
Installation and Connection
Connections to the CopperHead 3400 Base Station
Fig. 3-3: CopperHead 3430AP Base Unit Connections
Multi‐Pin Cable Assemblies Used with the CopperHead 3400 Base Station
A Camera Remote Control (Remote) Connector–
Connect either your Camera Remote Control or the Grass Valley Universal Controller –
CHRCP-2050A or CHRCP-2050-LCD.
See Appendix B for a list of Grass Valley-supplied cables
B Data/GPI Connector
Connect a Remote Pan/Tilt/Zoom Control Unit and connect to one GPI Out and two GPI
inputs. Usage of GPI/Os other than Tally and Intercom control is outside of the scope of this
User Guide.
Serial Control devices using RS232/422/485 can be controlled over this signal path. See
page 61 for wiring details
C Audio In Connector
Connect Intercom Program Audio and four Production Audio Channel outputs.
See page 61 for wiring details
Connectors into and out of the CopperHead 3400 Base Station
This information duplicates some of that from above sections. It is presented here to provide a
single list of all Base Station connections. . Connectors that are present on the CopperHead 3400