Grass Valley K2 Storage System Instruction Manual v.3.2 Nov.18 2008 - Manual (Page 121)

July 15, 2008 K2 Storage System Instruction Manual 121
Powering on the control point PC
• If the ports are connected to active network devices, the LEDs behave according
to the LED Mode selected. In the default view mode (Link), the LEDs should be
on.
• If the ports are not connected to active network devices, the LEDs will stay off.
Powering on the control point PC
Use the following procedure to power on K2 Storage System’s control point PC and
verify proper operation during power up of the system.
1. Power up and log on to the PC using standard Windows procedures.
2. Start and log on to NetCentral.
3. NetCentral reports devices as offline. As each device of the K2 Storage System is
powered on, check NetCentral to verify the device’s status