Grass Valley K2 Storage System Instruction Manual v.3.2 Nov.18 2008 - Manual (Page 500)

500 K2 Storage System Instruction Manual July 15, 2008
Chapter 13 Administering and maintaining the K2 Storage System
The Bind dialog box opens showing all unbound disks for the controller listed in
the Available Disk list.
2. Leave Full Bind unchecked. Refer to the previous section “About full/background
bind” .
3. In the Bind TYPE drop down box, select the RAID type. Refer to the installation
chapter earlier in this document for your level of storage system for specific
instructions regarding RAID 1, 3, 5, and 6.
4. In the Available Disks box, select contiguous disks at the top of the list as
appropriate for the RAID type. (TIP: Use ‘shift-click’ or ‘control-click’ to select
disks.)
5. Click the add (arrow) button to add disks to the Selected Disks list.
NOTE: As an aid in identifying a disk module’s physical location, select it in the
Selected Disks list, then click
Identify Disks. This causes the disk drive LED to flash.
6. Click OK to close the Bind dialog box and begin the binding process. The Progress
Report dialog box opens, showing the status of the binding process.
7. Close the Progress Report and repeat these steps for other unbound disks.
8. Upon 100% completion, click Close in Progress Report window.
9. Restart the K2 Media Server.