Grass Valley K2 Storage System Instruction Manual v.3.2 Nov.18 2008 - Manual (Page 387)

July 15, 2008 K2 Storage System Instruction Manual 387
Nearline 10 storage system power-off procedure
5. Release the power button in about 5 seconds, when the RDY LED blinks more
quickly, at a rate of about 2 blinks per second. Do not hold down the power button
for longer than 15 seconds.
The power button on the RAID controller turns off power for the primary RAID
chassis and any connected Expansion chassis. Power-off normally occurs within
20 seconds and is indicated when LEDs other than those on the power supplies go
off and the fans stop rotating.
6. Wait for RAID power-off to complete before proceeding.
7. Power-off all Ethernet switches.
8. Power-off the control point PC and/or the NetCentral server PC, if necessary.