Grass Valley Kayenne v.3.0 - Manual (Page 129)

KAYENNE — User Manual 129
Button Mapping
Note When you map a Shift or DELG button, that button will be mapped in the
same location across all Shift Levels.
If a Kayenne system’s NV memory is cleared, local panel button mappings
will revert to the factory defaults shown above.
Source Button Mapping
On the Kayenne system, each bank on the Control Panel (Source Select
Modules and Local Aux Module) can have its own independent source-to-
button mapping, if desired, as well as each Remote Aux Panel. Typically
button mappings on the Control Panel are set the same, for operating sim-
plicity. However, in some situations individual bank mapping can be
advantageous. For example, on a show with a large number of sources you
can place all the DDR and VTR sources on one bank, all the cameras on
another bank, etc., and then have direct access to any desired source. If you
use this feature, your system should be equipped with source name dis-
plays on all banks so the different sources can be identified.
Buttons 9,10 eDA,eDC
Buttons 11-14 Pg A - Pg D
Button 15 Blk
Button 16 Test
Buttons 17,18 Bg 1,Bg 2
Buttons 19-22 M1 D - M4 D
Button 23, 24 Shift, Shift
Button 25 Delegate
Table 8. 2-ME/25 Factory Configured Source to Button Mapping 4th Level
Panel Button (25) 4th