Figure 222 – Grass Valley Kayenne v.3.0 User Manual
Page 342
342
KAYENNE — User Manual
Section 3 — System Operation
2.
Go to the Timeline Events menu and touch the button of the desired
device to delegate the menu to that device (
Figure 222. Timeline Events Menu, Device Delegated
3.
Touch the
Load
button on the right.
4.
Touch the
Cue
button to enter the timecode:
•
If you want to play the clip from its starting point, it will automati-
cally cue to this location when loaded.
•
If you do not want to play the clip from its starting point, either cue
the device to the desired location using the Multi-Function Module
(Devs menu) or Device Control Module, or enter the timecode
value manually.
5.
Set up the Control Panel to the desired state, making sure the DDR
source is not selected on the PGM PST A bus.
6.
Learn this state to an E-MEM register as the first keyframe of the effect.
7.
Go to a point later in your effect giving sufficient time for the clip to
load and cue. For example, go to three seconds by pressing
GoTM
,
3
,
•
,
ENT
.
8.
Touch the
Clear Events
button in the Events pane to deselect the old
commands. This helps prevents accidental multiple load and cue
commands in the same effect.