Grass Valley Kayenne v.3.0 - Manual (Page 333)

KAYENNE — User Manual 333
Device Control Operations
2. Press the Link Cue button (high tallies blue).
3. Learn the Q-MEM register.
4. Press the LRN button.
a. Optionally, press the Play button (flashes green) to add a play
command (so when the cue register is recalled, the clip will load and
play).
5. Press the Cue Register button to recall the cue.
Note To see the link cue status, press the lettered button then the Link Cue button.
Learning Additional Devices
You can link multiple devices in addition to the devices associated with the
lettered buttons using the Cue Device Selection menu (
Figure 217 ). Each
clip will need to be setup with mark-in/out points etc. prior to creating the
link.
Figure 217. DCM—Cue Links
Hold down a lettered button ( A - F) and press the Link Cue button (high tallies
blue), the Cue Device Selection menu is displayed ( Figure 217 ). Press the
device buttons to add (or remove) devices as part of the cue then press the
ENT (or Link Cue ) button. All device buttons added to the cue will tally blue.
Pressing the CLR button clears all devices from the cue.
Note Both loop cue status and link status are always learned into the cue; if the
Loop button is high tally, then a loop is learned and if Link Cue button is high
tally blue, then the multiple devices are linked into the cue.
Go To
TC TC
Mark
In In
Link Link
Cue
Cue
Set Set
In
In
Mark
Out Out
Set Set
Out
Out
Cue Cue
Load
Loop Loop Var
Sh Shutl
A B C D E F
CLR
ENT
K2-1 K2-4 K2-3 K2-2
CS-1 CS-4 CS-3 CS-2
IS 1 IS 4 IS-3 IS 2
IS 5 IS 6
8623267_34
G V / B r i g h t S t a r
I Ø Ø : Ø Ø : Ø Ø : 2 2 O U Ø Ø : Ø Ø : Ø 7 : 2 4
D Ø Ø : Ø Ø : Ø 7 : Ø 2 T C Ø Ø : Ø Ø : Ø Ø : Ø Ø
C S - 1 1 2 3 4 5 M I S C 4