Grass Valley LVS 100 v.3.15 - Manual (Page 321)

Diagnostics
Profile LVS Event Management System Instruction Manual
9-31
ENC indicates the rotation speed of the knob. When you turn the knob clock-
wise, the value followed by the –> symbol varies depending on the rotation
speed. When you turn the knob counterclockwise, the value following the <–
symbol varies in the same fashion.
CLTCH toggles ON and OFF whenever you press the SHTL key. When the
CLTCH is ON, the clutch and stopper are set to the knob. The value of ORG
turns to 1 only when the CLTCH is set to ON and you turn the knob.
Check that each value varies while operating the lever, the lever handle button,
and the knob with and without clutch.
After the test is completed, press 0 to return to the Main menu.
NOTE. If your Live Controller has firmware version 1.11 or lower, pressing 0 at
this step causes the diagnostic routine to exit and the Live Controller system to
start. To perform the next diagnostic test, re–run the diagnostic routine by
powering off and on again. This problem has been fixed in firmware version 1.12
and higher.
Press 6 when the Main menu is displayed on the LCDs. Then following menu
appears.
[S-E2PROM TEST] 0: Return to menu
PLAY: Starting S-E2PROM R/W test.
Press PLAY to perform the serial EEPROM test. When the test starts, the
following message appears on the lower LCD.
S-E2PROM test executing...
Serial EEPROM Test