Bang & Olufsen BeoVision 9 User Guide - Manual (Page 46)

Set up your television
Important
Ventilation
Follow the guidelines for placement and connection described on this and the
following pages.
Place the TV
When you place the TV, remember that the built-
in motor unit will turn the TV to a preset position
when you switch it on.
Remove supports
When you have placed the TV, remove the two
supports beneath the front frame.
Fasten base cover
The cover has strips of double-coated tape on the
back.
Before you fasten the cover permanently, try to
put it into place without removing the tape
backing.
Due to the heavy weight of the TV, any moving or
lifting of the TV should be performed by qualified
personnel – using the proper equipment.
Unscrew the screws inside each support.
To ensure proper ventilation, allow for at least 5 cm (2") of space on each side of the TV and 10 cm (4")
above it. Do not cover the ventilation holes on the rear.
At overheating (flashing standby indicator and an on-screen warning), switch off the TV to let it cool.
You cannot operate the TV during this time.
1
2
44