Bang & Olufsen BeoVision 9 User Guide - Manual (Page 48)

Expand your setup
Information
Your TV supports a wide range of additional equipment. You can even connect a
projector or a home automation system to control room lights and curtains.
Connect video recorders only to AV1 or AV2.
Disconnect from the mains
While expanding your setup, the TV must be
disconnected from the mains.
Disconnect TV from mains Switch off TV
Remove the cable cover
Remove the cable cover to get access to the
connection panel.
Tilt main connection panel for-
ward
Connect additional equipment
To operate non-Bang & Olufsen products with
Beo5, attach a Bang & Olufsen IR-transmitter to
each product. See also pp. 48-49.
Make the connections
Select corresponding socket
marked CTRL
Switch on the TV
Always attach covers before you connect the
TV to the mains.
Connect TV to mains supply Attach all covers Switch on TV
Press B to open the small door to
sockets for temporary
connections
Release the two locks A and
pull off cover
‘AUTO SELECTION’
‘TIMER RECORDER’
‘HDMI’
Automatic selection of connected sources, when the TV is on and detects a signal.
Activate the Timer recording option for a connected recorder. Available if you do not have the optional
Bang & Olufsen hard disc recorder. Only available in the ‘AV1’ and ‘AV2’ menus, and can only be
activated in one of these menus at any time.
Equipment connected via an HDMI IN socket. If you have set the ‘HDMI EXPANDER’ in the
‘CONNECTIONS’ menu to ‘YES’, the ‘HDMI-C’ option in the ‘AV’ menus is replaced with ‘HDMI-C1’,
‘HDMI-C2’, ‘HDMI-C3’, and ‘HDMI-C4’.
B
A
46