E-Tech STYLUS Pro WT7900 - Manual (Page 69)

69
Using Film and Other Media | 69
6. If you see a question on the display about paper settings, select Yes if the
settings are correct, or select No and then change the settings. Press OK
to save your settings.
7. Print your page. After it is finished, the sheet stays in the printer.
8. To remove your print, press the d button while holding the sheet.
Adjusting the Platen Gap for Thick or Thin Paper
When you print on unusually thick or thin paper, you may need to adjust
the platen gap setting.
STANDARD is the default setting. However, if print
quality is not satisfactory when using very thin or very thick stock, you may
need to change this setting
.
1. Press r Menu .
2. Press r again to select PRINTER SETUP , then press r to select
PLATEN GAP .
STANDARD is selected as the current setting.
3. Use the u or d button to choose NARROW , WIDE , WIDER , or
WIDEST .
4. Press OK to save the setting. A check mark appears next to the selected
setting.
5. Press to exit the menu.
If you’ve selected a non-standard platen gap, the following symbols appear in
the corner of the display to remind you of the narrow or wide setting:
When you switch media, don’t forget to change the setting back to
STANDARD.
Widest
Wider
Wide
Narrow
Note: If you notice head
strikes on your prints,
make sure your paper is
flat. You can also try
changing the PLATEN
GAP setting to WIDE. If
that doesn’t solve the
problem, try changing it
to WIDER.
Caution: To avoid
damaging the printer,
make sure you do not
select the NARROW
setting when you print
on thick media.