E-Tech STYLUS Pro WT7900 - Manual (Page 92)

92
92 | Maintaining and Transporting the Printer
Changing the Date and Time
1. Press r Menu .
2. Press d until MAINTENANCE is highlighted, then press r.
3. Press d until you see CLOCK SETTING , then press r .
4. Use the d, u, and r buttons to set each item in the date and time,
displayed in the following format: MM/DD/YY HH:MM .
5. Press OK to save the setting, then press to exit the menu.
Using Maintenance Mode
Maintenance mode lets you make special settings and perform maintenance
procedures that may be needed occasionally. You can use maintenance mode
to do the following:
• Change the language or units of measurements used on the printer’s
control panel menus.
• Adjust the maximum value for roll paper tension.
• Run a “super strong” cleaning cycle
• Change the number of cleaning cycles the printer automatically
performs when it detects clogged nozzles.
• Return all of the printer’s control panel settings to their default values.
Follow these steps to use maintenance mode:
1. Make sure the printer is turned off.
2. Press and hold the button, then press the P power button and
hold it until the printer turns on and the LCD displays
MAINTENANCE MODE.
Tip: You can use the
Printer Setup menu to
enable the roll paper
counter, paper size
check, and several other
printer features (see
page 128).
You can also use the
EpsonNet Config utility to
set up a time server. This
disables the CLOCK
SETTING menu.