PLANET IPX-2000 - Manual (Page 13)

PLANET IPX-2000 user’s manual
13 of 51
3 Service Configuration
This section describes details to configure various services built in the IP PBX.
3.1 NTP service
Select Service -> NTP service to specify a NTP server for network time synchronization. You
can enable or disable NTP service at any time.
3.1.1 Enable NTP service
Select Enable radio button, enter the fully qualified domain name or the IP address of a NTP
server, and then click Save button.
3.1.2 Disable NTP service
Select Disable radio button, and then click Save button.
3.2 SNMP service
Select Service -> SNMP service to specify Simple Network Management Protocol (SNMP)
parameters for networking status retrieval. You can enable or disable SNMP service at any time.
3.2.1 Enable SNMP service
Select Enable radio button, enter System Location, Administrator Contact, read-only
community, and then click Save button. Example settings are Taipei Office, John Doe
[email protected], and public for the three fields.
3.2.2 Disable SNMP service
Select Disable radio button, and then click Save button.