Ericsson LBI-38732E - Manual (Page 47)

are assigned to select systems. If the SYS-
TEM/GROUP/CHANNEL knob is assigned to select sys-
tems, then the
, , . keys are assigned to
select groups. System, group and channel selection is
the primary function for these controls.
Either systems or groups can also be selected by
entering the select mode and following the selection
mode rules described earlier. Only the selection as-
signed as the primary function of the
,
,
.
pair
will be available for this method of direct selection. For
example, if system selection is the primary function of the
, , . pair then only the system select mode will
be usable and direct group select will be unavailable. The
system select or group select modes are entered by
pressing SYS or GRP, respectively, from the standard
receive mode. Using
, , . after entering a
particular selection mode in this manner is the secondary
function of these keys.
System Selection
Several methods, some of which depend on program-
ming, can be used to select a new system. These proce-
dures are presumed to be starting from the normal
receive display.
METHOD 1: If system selection is programmed to the
SYSTEM/GROUP/CHANNEL knob, se-
lect a system by turning the SYS-
TEM/GROUP/CHANNEL knob to the de-
sired system number position (1-16). The
display registers the new system name on
line one. If the knob is moved to a position
47