Ericsson EDACS LBI-39077 - Manual (Page 9)

GETTING STARTED LBI-39077
9
•
The operation menu window is located just below the selected (highlighted) group in the group menu line, and lists
the individual operations that can be selected within the selected group.
•
The HELP window is located just above the lower left corner of the screen, and prompts you with information about
the selected (highlighted) individual operation.
•
The single-line alert and status message field is located just below the HELP window, and is used to give
additional information for the combination of circumstances that exist at the moment (the message field is blank
when there is no message). Messages may alert you to special actions, or the status of the operation you have
requested.
Figure 1 shows the Main Menu screen as it first appears, with the Edit group selected (highlighted) in the group menu line
and the System config operation selected (highlighted) in the operation menu window. To select some other group, press the
right (or left, to backtrack) arrow key until the desired group is highlighted. To select some other operation from the operation
menu window, press the down (or up, to backtrack) arrow key until the desired operation is highlighted. If you press the up
arrow key one too many times, the operation menu window will disappear. Press the down arrow key and it will re-appear.
Selecting another operation will change the information in the HELP window.
Sample Main Menu screens for each of the other four operational groups are shown in Figures 2, 3, 10, and 14.
EDIT GROUP
The Edit group of operations is the first group shown in the Main Menu. Figure 1 shows a sample Main Menu screen with the
Edit group selected. When this group is first selected, the System config operation is automatically selected. Selecting
another operation will change the information in the HELP window.
EDACS GTI Configurator/Database Manager V1.3 (SUPERVISOR mode)
ì Edit View Comm File otHer м
ЪДДДДДДДДДДДДДДД¿
³ System config ³
³ Telco config ³
³ DID numbers ³
АДДДДДДДДДДДДДДДЩ
ÉÍHELPÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍ»
ºSelect item with arrow keys and º
ºENTER or capital letter. ESC to quit º
º º
ºEdit System Config allows the System º
ºConfiguration data to be changed. º
ºAdditions, deletions and modificationsº
ºcan be done. Then use Comm Update. º
º º
ИНННННННННННННННННННННННННННННННННННННН¼
Figure 1 - Sample Main Menu Screen with the Edit Group Selected
The Edit group of operations allows you to make additions, deletions, and modifications to various parts of the GTI database.
This group includes the following specific operations:
•
The System config operation is used for parameters that are common to a specific system of GTI units at a specific
location.