Honeywell HRSD16 - Manual (Page 42)

Configuration
42
Synchronizing with a Standard Time Server
You can set up time synchronization between the DVR and standard time servers that
are available in most time zones and countries, or between this DVR and another DVR.
1. Highlight the Time Sync. tab. The Time Sync. screen displays.
Figure 3-12 Time Sync. Screen
2. Highlight the field beside Automatic Sync. and press to toggle between On
and Off. When set to On, the Time Server and Interval fields become active.
3. Highlight the field beside Time Server and press . Use the virtual keyboard to
enter the IP address or domain name of the time server.
Note You can use the domain name instead of the IP address if you
have already set up the DNS Server when setting up the LAN.
4. Highlight the field beside Interval and press . Set the time interval for
synchronization from 30 minutes to 1 day at various time intervals.
The Last Sync-Time field displays the last time the DVR was synchronized with the time
server.
5. Highlight Run as Server and press to toggle between On and Off. When it is
On, the DVR you are setting up runs as a time server.
6. Save your changes by highlighting Save and pressing . Select Cancel to exit
the screen without saving the changes.
Storage Screen
Highlight Storage in the System menu and press . The Storage Information Setup
screen appears and displays information about the DVR storage devices.