Hand Held Products 9500 - Manual (Page 122)

7 - 20 Dolphin® 9500 Series User’s Guide
Help Menu
Tapping Help opens the help menu. Select Online Help to access online help. Select About to review software version
information.
Status Bar
The status bar is displayed at the bottom of the main screen and indicates the connection status between the network card and
the access point.
The status bar displays one of the following depending on the status of connectivity:
• “Not Associated”
• “AP : [Name of the SSID] MAC : [MAC address].”
Port Menu
On the main screen, tapping on a port opens a popup menu that allows the port to be enabled or disabled, configured, or deleted.
The port menu enables you to use 802.1X authentication, change the port configuration, or remove it from the port list. If there
are no entries in the Port list, follow the advice in the troubleshooting section to resolve the problem.
Enable and Disable These commands enable or disable 802.1X authentication on the port. The port should be enabled
before the protocol is started. Enabling a port is not the same as starting it (see
Client Menu on page
7-18); however, both actions are required for the Client to work.
Configure Opens the port configuration screen.
Status Bar