Hand Held Products 9500 - Manual (Page 123)

Dolphin® 9500 Series User’s Guide 7 - 21
Delete Removes an adapter from the port list. An unused port may be deleted from the port list. The radio
card must not be in the device or the radio must be turned off.
Ports appear in the list only when the 802.1X protocol binds to the adapter. The protocol binds to the
adapter when the adapter is in the device and the Client software is installed, or Install Protocol is
selected from the Client menu (see
Client Menu on page 7-18).
Configuring the Client
The Client is configured in two separate areas:
1. Client Configuration area - enables you to configure user settings and is accessed from the Client menu in the command
bar.
2. Port Settings area - enables you to configure Network Properties settings for individual wireless networks and is accessed
from the Port menu.
Configuration Screens
Both Client Configuration and Port Settings areas lead you through a series of setup screens. The following diagram displays the
different screens and how they are related:
Client Configuration Area
Each user account needs to define the protocol and the credentials used to authenticate a user. Because Windows Mobile
devices are usually small devices with a single NIC and, usually, a single user, the initial configuration is usually the only time
the software needs to be set up. The Client will need to be reconfigured if the device is used on multiple networks, or if different
users share the computer.
Note: Fields are be grayed out if not relevant to the selected protocol.