Hand Held Products 9500 - Manual (Page 241)

Dolphin® 9500 Series User’s Guide 13 - 5
Installing the Dolphin Mobile Base
To install the Dolphin Mobile Base, you need to mount it securely to an appropriate location and supply it with power.
Mounting the Mobile Base
The adjustable mounting bracket holds the terminal securely in place and gives the user a variety of options for mounting the
Mobile Base. When selecting a location, keep in mind that the power supply and serial connectors point straight out the bottom
panel.
Back Panel and Brackets
1. Loosen the turnscrew.
2. Insert the ball joint of the mounting bracket to the back of the bracket.
3. Insert the ball joint on the back of the Mobile Base into the other side of the bracket.
4. Tighten the turnscrew to secure both ball joints.
5. Secure the mounting bracket to the appropriate location.
Back Panel
Latch
The latch sits on top of the spring arm assembly and holds the back of the terminal securely in place. The graphic
above displays the mounting of a Dolphin 9500 terminal. There is another Dolphin Mobile Base that contains a
special latch to accommodate the pistol-grip handle on the Dolphin 9550.
Locking Tabs
When positioned as shown in the above graphic, the locking tabs secure the spring arm assembly, latch, and
terminal in place. When seating a terminal, turn both arms up to allow the spring arm to move as necessary while
the terminal is being inserted. After the terminal is seated, turn both arms toward the center to lock them.
Turnscrew
Power supply and RS-232
connectors (not in view)
Mounting Bracket
Locking tabs
Ball Joint
Bracket
Latch
Spring Arm Assembly
Ball Joint