Hand Held Products 9500 - Manual (Page 257)

Dolphin® 9500 Series User’s Guide 15 - 3
Back Panel
Power Switch
Toggle the power switch to turn the QuadCharger on and off.
Power Supply Connector
Use this connector to attach the power supply to the QuadCharger. The universal power supply accepts input
voltages between 90-265 volts.
Supplying Power to the QuadCharger
The QuadCharger must be connected to a power source via the Hand Held Products power adapter cable so that voltage is
adjusted appropriately.
1. Locate the AC power adapter cable and plug it into the power source.
2. Connect the power cable to the power adapter.
3. Connect the power cable to the supply connector on the back of the QuadCharger.
4. Press the power switch to the ON position.
The power LED illuminates green, and the charger performs a self-diagnostic test that lasts approximately five seconds.
Power Supply Connector Power Switch Status LED