Hand Held Products 9500 - Manual (Page 244)

13 - 8 Dolphin® 9500 Series User’s Guide
Mobile Base Serial Connector
The following diagram displays the pin diagram of the serial connector of the bottom panel of the Mobile Base.
Note: Signals referenced are for a DTE device.
The Mobile Base connector is straight to the printed circuit board (PCB). The ninth pin sends 500mA at 5V power out. This can
power a peripheral device, such as a mobile printer, as long as that peripheral device can accept 500mA at 5V.
Configuring the Terminal for ActiveSync Communications
1. On the terminal, tap Start > ActiveSync > Tools > Options. ActiveSync opens displaying the PC tab.
2. In the Use this PC drop-down list, select the name of the host PC.
Pi n # Description
1 Interna l Jumpe r to Pi n 6
2 TXD
3 RXD
4 DSR
5 GND
6 DTR
7 CTS
8 R TS
9 5 VO LT OUT