Henny Penny OFE/OFG-322 - Manual (Page 12)

Model OFE/OFG-321,322,323,324
2-12. VACUUM SWITCH
(Continued)
5. Using a Phillips head screwdriver, remove the screws securing
the vacuum switch to the shroud.
6. Install the new vacuum switch in reverse order.
To avoid property damage, do not tamper with, or disas-
semble this component. It is set and sealed from the
factory and is not to be adjusted.
2-13. SPEAKER ASSEMBLY
The speaker assembly emits audible signals to let the operator
(Gas Units) know when cooking and hold times are finished.
1. Remove electrical power supplied to the unit.
To avoid electrical shock or property damage, move the
POWER switch to OFF and disconnect main circuit
breaker, or unplug cord at wall receptacle.
2. Remove the control panel as discussed in Complete Control
Panel Replacement Section.
3. Using a Phillips head screwdriver, remove the four screws
securing the speaker to the shroud.
4. Install new speaker in reverse order. When plugging connector
into control board, be sure to align pins into connector
correctly.
2-12 203