Henny Penny OFE/OFG-322 - Manual (Page 27)

Model OFE/OFG-321,322,323,324
2-22. AUTOLIFT
ACTUATOR (MOTOR)
REPLACEMENT
(if applicable) (Continued)
9. Remove the 2 front mounting screws from the actuator support
plate.
10. Remove all the top screws, securing all the actuator support
plates to the back shroud, to help loosen the back shroud.
11. Remove all remaining back shroud screws to loosen the back
shroud from the unit.
12. Lift up on the entire back shroud assembly, enough to have the
top of the actuator and bracket assembly to clear the top of
the back shroud. Pull the top of the actuator and bracket
assembly away from back shroud, as shown in Figure 10.
Now, using a flat-blade screwdriver, push the clevis pin from
the bracket and actuator and using pliers to pull the pin
from the assembly. Actuator can now be removed from unit.
13. Reassemble in reverse order.
606 2-27