HP 310X - Manual (Page 73)

Network Statistics ❍
Protocol Info ❍
Configuration Page ❍
Refresh Rate ❍
Configuration:
Network Settings ●
Support Info ●
USB Settings ●
Other Settings ●
Network Settings
TCP/IP tab ●
IPX/SPX tab ●
AppleTalk tab ●
DLC/LLC tab ●
SNMP tab ●
Click on the Networking tab at the top of the web page. (Make sure that beneath
Configuration in the left column of the page, Network Settings is selected.) The
Network Settings
pages allow you to set or change configuration parameters for
TCP/IP, IPX/SPX, AppleTalk, and SNMP protocols. To assign a parameter setting,
enter the desired value and click
[Apply]
.
Notes
If you enter or change a configuration parameter value, click [Apply] to enable
your change, or click [Cancel] to erase your change.
●
Changes to the IP address will close the connection to the embedded web
server. To re-establish a connection, use the new IP address. ●
TCP/IP settings
Click on the Networking tab. If the TCP/IP tab is not highlighted, then beneath
Configuration in the left column of the page, select Network Settings , and then
select the TCP/IP tab in the second row of tabs across the page. To assign a
parameter setting, enter the desired value and click [Apply] .
TCP/IP Settings