FUJITSU ServerView Resource Orchestrator Cloud Edition J2X1-7611-03ENZ0 - Manual (Page 108)

Starting the Manager
Start the manager.
For details on how to start the manager, refer to " 2.1 Starting and Stopping the Manager ".
10.2 Backup and Restoration of Network Devices
This section describes how to perform the backup and restoration of network devices.
10.2.1 Mechanism of Backup and Restoration
By backing up network device configuration files, restoration of network device configurations can be done quickly when network devices
are replaced due to failures.
Up to 5 generations of network device configuration files can be backed up and saved If the number of saved generations exceeds 5
generations, older generations will be deleted, starting with the oldest generation.
Only 1 generation of network device environment files can be backed up and saved. If backup is performed, the saved network device
environment file will be deleted automatically.
This product supports the backup and restoration of network device configuration files for the following network devices.
Table 10.9 Network Devices that are Supported by Device Configuration File Management
Hardware
Network Device
Configuration File
Environment File
Fujitsu
SR-X series
config1
config2
None
IPCOM EX series
(*)
running-config.cli
startup-config.cli
ipcomenv- host_name - firmware_version_number - time .tgz
host_name: Target IPCOM EX series host name
firmware_version_number: current firmware version
number
time: The time when backup was performed
Example:
ipcomenv-ipcom-
E20L10NF0001B01-20120802-103845.tgz
NS Appliance
running-config.cli
startup-config.cli
nsappliance- IP_address .tgz
Example: nsappliance-192.168.1.1.tgz
Cisco
Catalyst series (*)
running-config
startup-config
None
ASA5500 series (*)
running-config
startup-config
None
Nexus 5000 series
running-config
startup-config
None
F5 Networks
BIG-IP Local Traffic
Manager series
config.scf environment.ucs
*: For details on the target network devices, refer to "Table 2.73 Supported Network Devices" in the "Design Guide CE".
10.2.2 Backup of Network Devices
Whether to back up the network device file is decided based on the "CONFIG_BACKUP" parameter in unm_mon.rcxprop file.
Backup is performed in the following cases.
- 94 -