FUJITSU ServerView Resource Orchestrator Cloud Edition J2X1-7611-03ENZ0 - Manual (Page 78)

When the Management Function for Network Device Configuration Files is Used
1. Announcement of planned maintenance operations.
2. Change the target network device to "maintenance mode".
3. Replace the network devices. (Hardware maintenance person)
4. Restore the configuration of the replaced network device using the network device file which was backed up beforehand in
accordance with the maintenance procedure of the network device.
- When performing restoration by logging in to the replaced network device directly
1. Retrieve the network device file which was backed up beforehand using the rcxadm netdevice cfexport command.
2. Restore the exported network device file using the maintenance procedure of the network device.
- When performing restoration using the restoration function of the management function for network device files
1. Configure the replaced network device definition as necessary for operation management.
2. Restore the network device file.
Information
- When the replaced network device is a "Cisco ASA 5500 series", restoration using the rcxadm netdevice cfrestore command
is not required.
Using the function of the "Cisco ASA 5500 series", the same configuration as the device in active state is reflected
automatically.
For details, please refer to the manual of the "Cisco ASA 5500 series".
- For restoration of network device files, please refer to " 10.2.3 Restoration of Network Devices ".
For the maintenance procedures for network devices, refer to the manual of the network device.
5. Back up the current network device files from the network devices with operational status.
If the content of the backed up device configuration file is up to date, this step is not required.
If the content is not up to date, take a backup of the network device configuration file using the rcxadm netdevice cfbackup command.
The date and time of backup can be checked using the rcxadm netdevice cflist command.
6. Check that there are no differences in the definitions that become a problem in the redundancy configurations that use the network
device files used in step 4 and the network device configuration file in the network device file backed up in step 5.
Export each network device configuration file using the rcxadm netdevice cfexport command and check the difference.
When there is difference that becomes a problem, please resolve difference following the maintenance procedure for network
devices.
For the maintenance procedures for network devices, refer to the manual of the network device.
7. Release the "maintenance mode" of network devices, when problems with network devices after replacement have been solved.
8. Notification that maintenance operations are complete.
9.5.1.2 When the Device to Replace has not Failed
This section explains the replacement procedure when the network device that is the target of replacement has not failed.
When the Management Function for Network Device Configuration Files is not Used
1. Announcement of planned maintenance operations.
2. Log in the network device directly to check if the target network device of replacement is in active status or standby status.
When the target network device of replacement is in active status, switch over the device with the standby network device of
redundancy configuration, and change the status of target network device for replacement from active status to standby status.
- 64 -