FUJITSU ServerView Resource Orchestrator Cloud Edition J2X1-7611-03ENZ0 - Manual (Page 79)

3. Change the target network device to "maintenance mode".
4. Back up the current environment (such as definitions) from the network devices that are switched to "maintenance mode".
5. Replace the network devices. (Hardware maintenance person)
6. Restore the configuration of the replaced network device using the environment backed up in step 4, following the maintenance
procedure for the network device.
7. Back up the current definitions from the network devices with operational status.
8. Check that there are no differences in the definitions in the redundancy configurations using environments backed up in step 7 and
environment definitions backed up in step 4.
When there is difference that is a problem, log in to the network device directly after replacement, and resolve the difference.
9. Release the "maintenance mode" of network devices, when problems with network devices after replacement have been solved.
10. Notification that maintenance operations are complete.
When the Management Function for Network Device Configuration Files is Used
1. Announcement of planned maintenance operations.
2. Log in the network device directly to check if the target network device of replacement is in active status or standby status.
When the target network device of replacement is in active status, switch over the device with the standby network device of
redundancy configuration, and change the status of target network device for replacement from active status to standby status.
3. Change the target network device to "maintenance mode".
4. Back up the current network device files from the network devices that have been switched to "maintenance mode".
If the content of the backed up device configuration file is up to date, this step is not required.
If the content is not up to date, take a backup of the network device configuration file using the rcxadm netdevice cfbackup command.
The date and time of backup can be checked using the rcxadm netdevice cflist command.
5. Replace the network devices. (Hardware maintenance person)
Information
When registering a "Nexus 5000 series" as a network device using the management function for the network device file, check the
note of "9.4.8.2 When Using the Network Device File Management Function" in the "Design Guide CE" before executing the
restoration in step 6.
6. Restore the configuration of the replaced network device using the network device file which was backed up in step 4, following
the maintenance procedure for the network device.
- When performing restoration by logging in to the replaced network device directly
1. Export the network device file which was backed up in step 4 with the rcxadm netdevice cfexport command.
2. Restore the exported network device file using the maintenance procedure of the network device.
- When performing restoration using the restoration function of the management function for network device files
1. Configure the replaced network device definition as necessary for operation management.
2. Restore the network device file.
Information
- When the replaced network device is a "Cisco ASA 5500 series", restoration using the rcxadm netdevice cfrestore command
is not required.
Using the function of the "Cisco ASA 5500 series", the same configuration as the device in active state is reflected
- 65 -