FUJITSU ServerView Resource Orchestrator Cloud Edition J2X1-7611-03ENZ0 User Manual
Page 68
To move a server to a different slot within a chassis, the server must be deleted first, and then registered again after being inserted in its
new slot.
Reconfiguring Hardware Properties after Server Replacement
-
For Rack Mount and Tower Servers
Use the following procedure to reconfigure properties for replaced hardware.
1.
If the agent or ServerView Agents has already been registered, power on the server.
Additional Information
When a server using SAN boot has a hardware exchange that results in the MAC address used for the admin LAN being
changed, the OS and an agent cannot be started.
In this case, the server should be started once, and the MAC address confirmed on the BIOS (hardware) screen. After the
MAC address is confirmed, power off the server again.
2.
In the ROR console server resource tree, right-click the target server and select [Hardware Maintenance]-[Reconfigure] from
the popup menu.
The [Re-configure Hardware Properties] dialog is displayed.
3.
Enter MAC addresses for the network interfaces used on the admin LAN.
This step can be skipped if no network interface was replaced.
-
Admin LAN MAC Address (NIC1)
Required only if the agent is not registered.
Additional Information
When a server is powered off for the reason given in the
in step 1, the item for input of the value
of NIC1 is displayed. In this case, input the MAC address confirmed in the
in step 1.
-
MAC address (NIC2) under SAN Boot/admin LAN redundancy
This item is only required for the following cases:
- When using the HBA address rename setup service
- When using GLS for admin LAN redundancy on the target server
- For the spare server of a managed server using admin LAN redundancy
4.
Click <OK>.
The original hardware properties of the selected managed server are updated with new hardware properties obtained from the
replacement server.
-
For PRIMEQUEST Servers
Use the following procedure to reconfigure properties for replaced hardware.
1.
Replace the system board or GSPB, and insert the server.
2.
After approximately 30 seconds, right-click the target server in the ROR console server resource tree, and select [Hardware
Maintenance]-[Re-configure] from the popup menu.
The [Re-configure Hardware Properties] dialog is displayed.
3.
Click <OK>.
The original hardware properties of the selected managed server are updated with new hardware properties obtained from the
replacement server.
-
For SPARC Servers/SPARC Enterprise Servers
Note that in this case there is no need to set the hardware information again.
- 54 -