Fostex MR-8MKII - Manual (Page 110)

110
MR-8mkII Owner’s Manual (Part data editing)
5) Press the [MENU/ENTER] key.
The display now returns to the part edit menu
screen, where “Paste Part >” is highlighted.
6) Press the [STOP] key to exit the menu mode.
<Note>: If you are going to carry out the
paste operation when no data is pasted on
the clipboard, the error message (“Clip-
board Empty!) is shown on the display and
the MR-8mkII does not accept the opera-
tion.
Press the [STOP] key to exit the menu mode
and copy the desired data to the clipboard
before carrying out the paste operation.
<Note>: If you are not satisfied with the re-
sult, press the [UNDO/REDO] key to undo
the operation (see page 103).
3) Rotate the JOG dial to select the paste
destination track(s), and press the
[MENU/ENTER] key.
The display returns to the previous screen.
4) Rotate the JOG dial to move the cursor to
"[ENTER]" on the screen, and press the
[MENU/ENTER] key.
The display shows "Please Wait", immediately
followed by "Completed" when the MR-8mkII
completes the paste operation.
If you want to cancel the part paste operation,
move the cursor to "[CANCEL]" on the screen,
and press the [MENU/ENTER] key.
The following procedure is assumed that the
LOCATE A point, the paste destination, is set
Pasting clipboard data
1) Rotate the JOG dial to select "Paste Part >", and
press the [MENU/ENTER] key.
The display now shows the screen for
selecting the paste destination track(s).
"<< Back" is initially highlighted .
2) Rotate the JOG dial to select "Paste Track = *",
and press the [MENU/ENTER] key.
You can now select the desired paste destination
track(s) by rotating the [MENU/ENTER] key.
The available options are:
• 1 through 8 (mono track)
• 1/2, 3/4, 5/6 and 7/8 (stereo tracks)
flashing
flashing