Installation – FMI BVC-50Y User Manual

Page 29

Advertising
background image

www.fmiproducts.com

122280-01E

29

InStaLLatIOn

Continued

Figure 34 - Installing Fireplace Screen

Ring

Screen

Push

On Nut

Screen

Rod

Bracket

Smoke Shelf

Screen

Rod

Fireplace Front

CAUTION: Gloves should

be worn when installing module

into fireplace. Metal edges may

be sharp.

1. Plug module into J-Box on the right side

of firebox floor.

2. Connect shutoff valve of module to flexible

gas line.

3. Connect wires from limit switch to module

(see Wiring Diagram, page 35).

4. Carefully place module into hearth in

firebox. Attach using 3 screws each on

left and right of module. Be careful not to

chip or break logs.

Figure 32 - Installing Module into Firebox

Figure 33 - Installing Floor Media

Scrap

Logs

Ember

Material

Ember

Flakes

Lava Rock

INSTALLING FLOOR MEDIA

1. Ember flakes should be placed upright

into grooves between ports on ember bed

(see Figure 33).

2. Place lava rock around base of burner on

hearth floor. Make sure burner ports are

not covered.

3. Gloves must be worn when working with

ember material. Pull ember material apart

into pieces no larger than a dime. Place

pieces loosely and sparingly directly over

holes of front burner (ember bed). This will

create a glowing ember appearance as

flame touches ember material. Do not block

pilot ports with embers. It is not necessary

to use all ember material provided.

4. Place scrap log pieces randomly as de-

sired on fireplace hearth floor around base

of log set.

5. Set andirons in place at sides of grate.

J-Box

Plug

Shutoff

Valve

INSTALLING SCREEN

Reinstall smoke shelf before installing screen.

See Removing and Installing Smoke Shelf

on page 18.
1. Mount screen rod brackets on left and

right side of firebox with #8 x 1/2" screws

provided (see Figure 34).

2. Slide round end of screen rod into rings at

top of screen. Attach one push-on nut to end

of rod before attaching last ring of screen.

3. Insert round end of rod into rod bracket

on left side of fireplace.

4. Mount flat end of screen rod with #10 x 5/8"

to center of smoke shelf (see Figure 34).

5. Install other screen rod in same manner.

Andiron

Advertising
This manual is related to the following products: