FMI BVC-50Y - Manual (Page 30)

www.fmiproducts.com 122280-01E 30
InStaLLatIOn
Continued
Figure 37 - Installing Bi-Fold Doors
Spring
Clip
Insert Pin
into Spring
Clip
Pivot
Hole
Insert
Bottom
Pivot Pin
into Hole
Fold Door
and Slide
Top Pins
Into Track
INSTALLING OPTIONAL GLASS
DOOR ACCESSORY
IMPORTANT: Install glass door
frame before installing glass
door.
INSTALLING FRAME
1. Remove screws from smoke shelf (see
Figure 26, page 19).
2. Mount top door frame and secure with
screws provided (see Figure 34, page 29).
3. Place bottom door frame on top of ash lip
at front of fireplace (see Figure 35).
4. Secure bottom door frame to brick with
two hex screws provided as shown in
Figure 35 using a 7/16" open end or
adjustable wrench.
Figure 36 - Installing Bottom Door Frame
Hex
Screw
Bottom
Door
Frame
Figure 35 - Installing Top Door Frame
Top Door
Frame
Smoke
Shelf
Ash Lip
Ash Lip
INSTALLING GLASS DOORS
Spring clips have been installed but some
adjustments may be needed. Install the doors
using the following steps:
1. With bifold doors completely folded, insert
bottom pivot pin into pivot hole located
near bottom corner of front face opening
and swing door to vertical position making
sure top pins slide into door track. Door
is installed when top door pin snaps into
spring clip.
2. Repeat step 1 for remaining door.
If you find the doors do not close properly or
do not appear level or straight, proceed with
section on door adjustment,
Figure 38 - Adjusting Bi-Fold Doors
DOOR ADjUSTMENT
Remove doors and slightly loosen lower pivot
clips and upper spring clips. Replace doors
and fully close them. Use 1/8" shims (any
material) to level doors. Once proper setting
is achieved, carefully open doors enough so
that you can access spring clips with a phillips
screwdriver. Tighten screws. See Figure 38.