FUJITSU SRS-9924-ABM - Manual (Page 34)

2-12
2
Using the T
e
rminal
This procedure is by no means the only way that
you can use Call Announce Intercom.
To announce a call by intercom, follow these steps:
1. Press the DN designated for Call Announce
Intercom. The intercom DN indicator lights
normally.
2. Dial the extension of the call recipient.
The recipient’s terminal sounds an alert tone,
immediately answers the call, and activates the
intercom feature.
3. Talk to the recipient.
If the recipient is set up for one-way intercom, pause
a few seconds to give the recipient time to press
the MIC-OFF button and respond. With two-way
intercom, the recipient can respond immediately
just by speaking.
Note: To transfer the call at the same time you
announce it, use the conference call transfer
procedure.