FUJITSU SRS-9924-ABM - Manual (Page 85)

5-17
5
NI
/
5E Custom
T
e
rminal Installation
NI ONL
Y
Selection 5:
Conference
It is necessary to assign the CONF feature to a key
using the following process.
Note: This step is not necessary if CONF is
assigned to Button 18, using Feature Activator
18 or 60.
1. Assign CONF as you would any feature
activator.
2. In the KEY ATTR MODE, press 5, CONF, then
press ENTER:
CONF APPEARANCE
SELECT ASSIGN KEY
3. Press selected CONF button. This screen
appears:
CONFKEY = (XX) FA = (XX)
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4. Press ENTER. The selected button’s LED turns
green.
CONFKEY = 16 FA = 18 or 61
COMPLETED
Note: This step is not necessary if TRAN is assigned
to Button 20, using Feature Activator 20 or 61.
1. To manually assign the TRAN key for your
terminal, press 6, ENTER to view the following
display:
TRANSFER REGISTRATION
SELECT ASSIGN KEY
2. Press TRAN (Multi-assign key #20), the following
display is shown:
TRANSFER REGISTRATION
TRANS KEY = (20) FA=20 or 61
Selection 6:
Transfer Key