FUJITSU SRS-9924-ABM - Manual (Page 93)

6-1
6
NI
/
5E Custom
T
e
rminal Accessories
Labeling the Set
Figure 6-1:
Digital Set
Cover Removal
CHAPTER 6
ACCESSORIES
To label the buttons on the set, you must first
remove the plastic cover over the front panel. Insert
a pointed object into the semi-circular notch at the
bottom middle of the plastic cover and lift the cover
upward. (Shown in Figure 6-1.)
Below the cover is a template. Write button labels
on this template to show the directory numbers or
features assigned to each button. Then lay the
template back on the front panel. Reinsert the
plastic cover.
Note: A template printing accessory is available
via the Fujitsu web site. It is described on the
following page.