Fostex FR-2 - Manual (Page 65)

65
FR-2 Field Memory Recorder (Chapter 6: MENU mode/Cue menu)
5) Move the character selection cursor to "OK", and press the [ENTER] key.
The FR-2 starts the operation for storing the entered name. When completed,
"Completed!" is shown on the screen and the display returns to the cue point list screen
as shown below.
You can enter up to 32 characters, however, only 16 characters can be displayed.
If a name has more than 16 characters, "->" is shown on the right of [ ].
6) Press the [HOME] key to exit the MENU mode.
When a USB keyboard is connected to the FR-2, you can carry out the following operation.
Character/numeric
keys
You can directly enter a character instead of selecting from among the character
options on the screen. Each time you press a character key, the cue name cursor
moves right.
Acts the same as the [MENU] dial on the FR-2 panel.
Moves the cue name cursor right and left.
Back space key
Deletes the character at the cue name cursor position, and slides all the subse-
quent characters left.
Insert key
Turn ON and OFF the INSERT mode. When it is ON, the cue name cursor is lit
solid. When it is OFF, the cue name cursor is flashing.
Delete key Deletes the character at the cue name cursor position.
Enter key
Used to fix the name entered.
Acts the same as moving the character selection cursor to "OK" and pressing the
[ENTER] key on the FR-2 panel.
To edit a character
highlighted (on the
cursor position) Use the [MENU] dial to select a desired character from among the character op-
tions, and press the [ENTER] key. The selection is fixed and the cue name cursor
moves right.
To move the cue name
cursor position Use [|<<] or [>>|] key. Or use the [MENU] dial to select "<-" or "->" in the character
options, and press the [ENTER] key.
To delete a character
on the cue name cur-
sor position
After moving the cue name cursor to the desired position, move the character selec-
tion cursor to "DEL" at the bottom, and press the [ENTER] key.
4) Enter the desired cue name.
See the table below for details about how to enter a name. Up to 32 characters can be
entered.
/ key
/ key
Inserts a front space at
the cue name cursor
position
After moving the cue name cursor to the desired position, move the character selec-
tion cursor to "INS" at the bottom, and press the [ENTER] key. (The FR-2 is put into
the INSERT mode and the cue name cursor condition changes to be lit solid.) After
that, select the character that you would like to insert by the character selection
cursor and press the [ENTER] key again. In order to cancel the INSERT mode,
select the “INS” and then the [ENTER] key. (The cue name cursor condition changes
to be flashing.)