Fostex FR-2 - Manual (Page 87)

87
FR-2 Field Memory Recorder (Chapter 6: MENU mode/Setup menu)
Setting error tone output condition (Error Tone)
1) Use the [MENU] dial to select "Setup" and press the [ENTER] key.
The display now shows the first page of the Setup menu.
2) Use the [MENU] dial to select "Error Tone" and press the [ENTER] key.
The error tone setting screen is shown.
3) Use the [MENU] dial to select the item to be set and press the [ENTER] key.
The current option of the selected item flashes and now you can select the desired option.
Depending on the selected item, the screen looks slightly different, as shown below.
When selecting "BATT Warning":
You can select between "On" and "Off" (by default, "Off" is selected). By setting it to "ON", the
error tone is output when the battery voltage lowers the certain level.
This menu item selects the condition in which the error tone is output.
The error tone can be output to warn you when;
* the input amplifier clips due to over level,
* the battery voltage lowers the certain level, or
* the remaining time of the memory card gets shorter than the specified time.
The following description is assumed that the FR-2 is now in the MENU mode by
pressing the [ENTER] key while the recorder is stopped.
When selecting "Input Clip":
You can select between "On" and "Off" (by default, "On" is selected). By setting it to "ON", the
error tone is output when the input amplifier clips.
When a USB keyboard is connected to the FR-2, you can carry out the following operation.
Acts the same as the [MENU] dial on the FR-2 panel.
Returns to the previous screen layer.
Enter key Acts the same as the [ENTER] key on the FR-2 panel.
/ keys
key