FUJITSU LIFEBOOK 990TX2 - Manual (Page 131)

U s e r I n s t a l l a b l e F e a t u r e s
L i f e B o o k 9 0 0 S e r i e s f r o m F u j i t s u
121
C A U T I O N
The floppy disk drive must be installed or
removed with the power off, unless you
are swapping it in Multi-function Bay 1
with the optional battery.
FLOPPY DISK DRIVE
For directions on installing a floppy disk
drive see To Install or Remove a Device in
Multi-function Bay 1, page 100. In addition an
optional external floppy disk drive may be
purchased and installed (page 103) for use when
Multi-function Bay 1 is needed for other uses.
(For information on the care and use of floppy
disk drives see Floppy Disk Drive in Section Two
on pages 34–36.)
Figure 4-5 Floppy Disk Drive
To install a floppy disk drive externally, you must
purchase an optional external floppy disk drive.
To Connect An Optional
External Floppy Disk Drive:
1. Close all files and exit all applications.
2. Turn off power to your notebook, close the
display and remove the AC adapter. (See
pages 24–25 for more information.)
3. Open the external floppy disk drive port
cover on the left side panel of your notebook
(Figure 4-6), by gently pulling on the front
edge of the cover and swinging it toward the
back of your notebook.
4. Align the external floppy disk drive cable
with the smaller connector towards the body
of your notebook with the wide side of the
connector down. (Figure 4-6.)
5. Insert the connector firmly into the port on
your notebook until it clicks.
6. Insert the other cable connector into the
back of the external floppy disk drive and
press firmly until it clicks.