FUJITSU LIFEBOOK 990TX2 - Manual (Page 151)

U s e r I n s t a l l a b l e F e a t u r e s
L i f e B o o k 9 0 0 S e r i e s f r o m F u j i t s u
141
To Remove Your Notebook
from the Port Replicator
1. Put your notebook in Suspend mode or
turn off the power.
2. Push the lever on the side of the station
backward until the docking device
connectors are completely clear of
your notebook.
3. Very carefully lift your notebook clear of
the Port Replicator.
P O I N T
If the notebook power switch is turned
off it is always safe to undock. You do
not have to turn on your notebook and
use the Eject PC feature for the LANdock
or put your notebook in Suspend mode
for the Port Replicator.
C A U T I O N
You may lose information if you do not
wait for the system to go to Suspend
mode before removing your notebook
from the docking device
C A U T I O N
The RJ-11 connector on the rear of your
docking device comes with a protective
cover to keep the connector clean. Be
careful to remove it before trying to make
a connection. Save the cover and replace
it when the connector is not in use.
Using Your Notebook
While it is Installed in the LANdock
There are differences you will notice between
using your notebook in and out of the
LANdock. Note that Windows 95 has added to
the Start menu,a PC Eject choice between the
Suspend mode and Shutdown selections. Use
the PC Eject choice to enable the undocking of
your LifeBook.
With the LANdock you have
added capabilities:
■
In the Windows 95 Start menu there is a
PC Eject choice between the Suspend mode
and Shutdown selections.(Use the PC Eject
choice to enable the undocking of
your LifeBook.)
■
Both an external mouse and an external
keyboard can be connected at the same
time. Be sure to plug them into the correct
PS/2 ports.