FUJITSU LIFEBOOK 990TX2 - Manual (Page 179)

T r o u b l e s h o o t i n g
L i f e B o o k 9 0 0 S e r i e s f r o m F u j i t s u
169
EMERGENCY CD-ROM DRIVE
TRAY RELEASE
If for some reason the eject button fails, you
can open the disk tray with a paper clip or simi-
lar tool inserted into the eject hole in the far
right side of the front of the tray. Straighten one
side of a paper clip and push it gently into the
hole. The tray will pop out a short distance.
(Figure 5-1.)
When using the internal modem with applica-
tions which are not factory installed see the
application documentation.
Recovery Directions
1. Put the Recovery CD-ROM in the
CD-ROMdrive.
2.Start your notebook.
3. Set the operating system source to be the
CD-ROM drive.
4. Follow the instructions on your screen.
5. When recovery is complete, remove the
Recovery CD-ROM, replace it in its sleeve
and store it.
6. Restart your notebook.
7. Reset your operating system source to be the
hard drive,if you wish.
Figure 5-1 Emergency CD-ROM Tray Release
MODEM SETUP AND COMMANDS
The operating system and application software
that is factory installed detects the modem
characteristics and provides the necessary com-
mand strings to operate the modem. The inter-
nal modem operation is controlled by generic
AT commands from the operating system and
application software. The standard long form
result codes may, in some cases, be displayed on
your screen to keep you informed of the actions
of your modem. The operating system and
application software may suppress display of
the result codes. Examples of result codes are:
OK
NO CARRIER
NO DIALTONE
CONNECT 56000
(Connection complete at 56,000 bps.)
ERROR
FAX
RING (This means an incoming call.)
BUSY
NO ANSWER