FUJITSU LIFEBOOK 990TX2 - Manual (Page 141)

U s e r I n s t a l l a b l e F e a t u r e s
L i f e B o o k 9 0 0 S e r i e s f r o m F u j i t s u
131
MOUSE
Make sure the connector on your device is the
correct PS/2 type. The PS/2 ports are on the
right side of your notebook. Align the arrow on
the connector to point to the bottom of your
notebook and push it in until the connector
seats.A mouse may be installed and will be
automatically recognized by your notebook
without restarting or changing setups. (See
Figure 1-6 on page 7.) A mouse may be installed
in either PS/2 port.
KEYBOARD
Make sure the connector on your device is the
correct PS/2 type. The PS/2 ports are on the
right side of your notebook. Align the arrow on
the connector to point to the bottom of your
notebook and push it in until the connector
seats.A keyboard or numeric keypad may be
installed and will be automatically recognized
by your notebook without restarting or
changing setups. (See Figure 1-6 on page 7.)
A keyboard or numeric keypad may be installed
on either PS/2 port.
MICROPHONE
Make sure that your mono microphone is
equipped with an 1/8" (3.5 mm) mono mini-
plug. The microphone jack is on the right side
of your notebook. Make sure the plug is aligned
and push it into the jack until fully seated.
(See Figure 1-6 on page 7.)
STEREO LINE IN DEVICES
Make sure that your stereo line in audio device,
a cassette recorder, for example,is equipped
with an 1/8" (3.5 mm) stereo mini-plug. The
stereo lin in jack is on the right side of your
notebook. Make sure the plug is aligned and
push it into the jack until fully seated.
(See Figure 1-6 on page 7.)
HEADPHONES
Make sure that your stereo headphones are
equipped with an 1/8" (3.5 mm) stereo mini-
plug. The headphone jack is on the right side of
your notebook. Make sure the plug is aligned
and push it into the jack until fully seated.
(See Figure 1-6 and page 7.)
TELEPHONE LINES
To attach a telephone line to the internal modem
open the rear panel connector cover or, with the
cover closed, slide the panel in the connector
cover slightly open to reveal the RJ-11 jack. Plug
one end of the telephone cable into the tele-
phone line outlet.Orient the telephone cable
with the release latch on the connector up. Push
it into the jack until it clicks and latches. (See
Figure 1-7 on page 8.)