FUJITSU LIFEBOOK 990TX2 - Manual (Page 61)

U s i n g Y o u r L i f e B o o k 9 0 0 S e r i e s
L i f e B o o k 9 0 0 S e r i e s f r o m F u j i t s u
51
6. References to the device’s drive letter listed
under ‘My Computer’and ‘Windows
Explorer’ will automatically be removed.
7. The taskbar icon and its ToolTip balloon will
be updated to reflect the new device inserted
in the bay.
Inserting Devices
To insert a device into the bay:
1. Your notebook should already be in suspend
mode. If it is not, proceed to the ‘Removing
Devices’ section and follow the steps to
suspend the computer. Failure to do so
can cause damage to your computer or
the device.
2. You can now safely insert the device into the
bay of the notebook without any damage.
3. Press the resume button which will reactivate
the notebook from suspend mode.
4. The software will automatically detect the
new device and place it online.
5. Depending on the device, one or more drive
letter(s) will automatically be created and listed
under ‘My Computer’and ‘Windows Explorer’.
6. The taskbar icon and its ToolTip balloon will
be updated to reflect the new device inserted
in the bay.
Control Panel
Tioman adds a Control Panel application called
‘Device Bay’ to your system. You can use this to
display information about the bay and the
inserted devices. You may also insert and
remove devices as described in the previous sec-
tion, using the button within the Device
Bay dialog.
Uninstalling Tioman
1. Open the Control Panel folder located under
‘My Computer’.
2. Open the ‘Add/Remove Programs’ icon.
3. Select the Agate Tioman entry from the list of
currently installed programs.
4. Click on the Add/Remove button to launch
the uninstall application.
5. The setup wizard will guide you through the
rest of the uninstall process.
6. Tioman software will be removed completely,
the next time Windows 95 is started.
Secondary Hard Drive Swap Limitations
If you ever boot with the second HDD installed
in Multi-function Bay 2 and try to swap it,an
error message “Removing INT 13 Devices is not
supported...” appears. This error occurs because
Windows configured the hard drive as an INT
13 drive and remembers the setting in the
Registry. The following steps are required to
enable the Tioman Proswap software to swap
out the second HDD.
When you see the swap failure message perform
the following steps:
• Boot system without the second HDD
• Swap in the second HDD
• Go into Control Panel/System/Device
Manager
• Look under Disk Drives